|
|
Post by blownmoney on Mar 7, 2010 22:42:30 GMT -5
|
|
|
|
Post by blownmoney on Mar 8, 2010 6:31:23 GMT -5
thinks jim ive seen cars that need more hit to work first run we left at 2500 an real slow on the throttle an it just moved out wasnt trying to run a number just shackdown run was go to sneak up on it as day went on we drop wheeley bars they are the old spring tip they were on the ground ! that was soom of it i think didnot get to run again done burn out started poping out #2 think i my have got the head gasket we did put the bars back iwas go to bring it up on the conv an hing on an shut my eyes just wont to no im going the right way by doing so by hiting the tires harder i have a 4.30 gear put together an 4.10 thats not in a thirdmember yet was going to try to get to work with 4.56  ive broken 3 ring a pinons with the cluths thing like ive siad im gun shy |
|
|
|
Post by slingshot383 on Mar 8, 2010 21:36:24 GMT -5
Launch harder, leave the tires up so that they haze just ever so lightly, have the wheelie bars 3" - 4" off the ground. The slicks are your suspension, to much tire pressure and ir wil hop on the launch, to little, and it will ball up the slciks and, you guessed it, hop.
|
|
|
|
Post by blownmoney on Mar 8, 2010 23:00:47 GMT -5
thinks i well they that this is all new to me i had a old wood sling shot years ago it was flat out of the hole at 3500 off trans brake 5500 stall this has a lot more motor than it had sounds like i need some ball !!! an light it up ? |
|
|
|
Post by my23taltered on Mar 8, 2010 23:19:00 GMT -5
be careful with spring loaded wheelie bars stood mine on end with them
|
|
|
|
Post by blownmoney on Mar 9, 2010 7:10:09 GMT -5
the moto is high in the car it well get up i think? could i pull springs out an put in tubing in with the flat srings on the bottom or make a 8 or 9 footer single wheel if so would mild steel be ok i have to go about 120 miles to get chome molly an what size tubing well work if i have to go that way
|
|
|
|
Post by blownmoney on Mar 9, 2010 7:42:43 GMT -5
good news i found the #2 problem rocker backed off did a compresion check all looked ok fired up all sounds fine runing like atop
|
|
|
|
Post by my23taltered on Mar 9, 2010 8:58:48 GMT -5
id build a new wheelie bar the flat with the spring loaded is what i had on my car it was ok till i found the tuneup then strait up there is just not enough strength would say mild steel properly constructed and braced would work but molly would be lighter and better
|
|
|
|
Post by blownmoney on Mar 9, 2010 9:07:33 GMT -5
just need to make a trip to tenn to get soom tubeing what size do i need
|
|
ive broken 3 ring a pinons with the cluths thing like ive siad im gun shy
